twislaandClaude Opus 5.5
1a0baf4ac7
- lib/wifi (host-tested): SavedNetworks (up to 8, validated, hidden flag, persisted) and WifiController (joins the strongest Saved Network, tries hidden ones in turn, backoff 10/30/60 s, connect timeout, Monitoring override, radio off without Saved Networks) - WifiService carries out the controller's actions, sets the EU country code, and syncs the Clock over SNTP without touching the TZ - Wi-Fi On/Off setting; Settings > Wi-Fi page: status, add from a scan or a hidden network, forget - Status Bar: W + signal bars, W? while searching, MON while monitoring - Serial: wifi add / wifi status (replaces the step 1 heap probe) Verified on the device: joins the test network ~5 s after boot, clock set over NTP, ~129 KB free heap while connected. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01EhqxQ49eCju4CzKYNjZzwT
roro9stack
A multi-app firmware for the M5Stack Cardputer ADV with the Cap LoRa-1262. It's a Meshtastic-compatible mesh messenger, plus Wi-Fi tools, IRC, GNSS and more. Licensed GPL-3.0.
- Domain language: CONTEXT.md
- Decisions: docs/adr/
- Milestones: docs/milestones/
Requirements
Only Docker is needed. PlatformIO and the ESP32 toolchain run inside a container, and are cached in the roro9stack-pio Docker volume. The first build downloads about 1 GB and takes a few minutes.
Build and test (local CI)
scripts/ci.sh
This runs the host-side unit tests (test/, native environment), then builds the firmware. The output is .pio/build/cardputer-adv/firmware.factory.bin.
Flash
-
Connect the Cardputer by USB-C.
-
Run:
scripts/flash.sh # auto-detects the port; or: scripts/flash.sh /dev/ttyACM1This uploads the firmware, then opens the serial monitor. Quit the monitor with
Ctrl+C.
If the upload can't connect, put the device in download mode: hold G0 (the button next to the screen) while plugging in USB, or while pressing reset. Then retry.
If you get "permission denied" on the port, your user needs access to the serial device. Run this once, then log out and back in:
sudo usermod -aG dialout "$USER"
Development aids
scripts/serial_log.sh [seconds] [command…] records the serial output, and can send commands to the firmware first. For example, scripts/serial_log.sh 30 short sleep:12 burst sets short screen timeouts, waits 12 s, then sends a burst of Toasts.
| Command | Effect |
|---|---|
burst |
Publishes 5 Notifications at once |
key up|down|left|right|select|back|home |
Injects a logical key press |
sound on / sound off |
Toggles the Sound setting (beep + LED) |
short / normal |
Screen timeouts 5 s / 10 s, or 30 s / 60 s |
wifi add <ssid><TAB><password> |
Adds a Saved Network (so credentials stay out of the repo) |
wifi status |
Prints Wi-Fi state, network, signal, clock and free heap |
scripts/flash.sh stops a running serial log first, since it would hold the port.