M2 step 3: GNSS Service, with standby and the clock from a Fix

The GNSS Service reads the receiver (UART 15/13, 115200, 1 KB buffer)
from its 50 ms tick and feeds the NMEA parser. With a Fix it sets the
clock (GNSS is the most trusted TimeSource) and refreshes it every 10
min. Settings gets GNSS On/Off and the coordinate format (Q64).

Off puts the receiver in standby with $PCAS12,65535, renewed hourly; On
wakes it with a hot start, $PCAS10,0. Both measured on the device: the
output stops within a second, and a command wakes it within a second.

Commands: gnss status (Fix, satellites per constellation, bytes and
sentences), gnss nmea on|off, gnss send <sentence>, gnss restart. The
probe is gone; never drive GPIO 15 (the receiver's output): the first
probe's swapped-pin attempt silenced it until a power cycle.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01EhqxQ49eCju4CzKYNjZzwT

lib/services/src/settings.h

@@ -21,6 +21,8 @@ enum class Setting : uint8_t {
     Sound,            // bool
     ProbeMacRaw,      // bool: probe-request Logs keep raw MAC addresses
     WifiEnabled,      // bool: the Wi-Fi Service stays Connected when a Saved Network is in range
+    GnssEnabled,      // bool: the GNSS Service reads the receiver (M2, Q58)
+    CoordinatesDms,   // bool: show degrees, minutes and seconds instead of decimal degrees (Q64)
     Count
 };